Chlorine Feeder CL-100 Conventional Connector

Chlorine Tablet Dispenser/Feeder CL-100 Conventional Connector

Chlorine Tablet Dispenser/Feeder CL-100 Conventional Connector is high capacity feeders offer user-friendly solution for sanitizing large residential and commercial swimming pool Using either chlorine or bromine tablets. They are heavy duty and able to provide automatic sanitization for pools up to 608000 litres. Chlorine Feeder CL-100 Both in-line and off-line plumbing installtions available in 2 sizes. Besides, this feeder can ONLY be Used with slow-dissolving Tri-chlor Do NOT mix with other type of chlorine or chemical, otherwise it may cause explosion or fire.

Youtube Video：Chlorine Feeder CL-100 Conventional Connector

Other Models：Chlorine Feeder

To open:

1. Fistly, shut off pump and turn DIAL CONTROL VALVE to OFF, Shut off any other in-line valves to prevent back flow; if applivable. Wait one minute.

2. Then Turn the LID counter-clockwise to open. Caution: do not inhale fumes from Chlorine Feeder CL-100.

To close:

1. To begin with, Press the LID, with o-ring seal, firmly onto BODY. And then engage the LID threads and turn clovkwise to stop lug.Chlorine Feeder.

2. Next Place DIAL CONTROL VALVE to desired setting, and open In-line valves and re-start pump.

INSTALLATION OFPCE03 ( IN-LINE )

1. The automatic Chlorine Feeder CL-100 Conventional Connector is for permanent installation in the pool water return line.

2. Initially, Always install Chlorine Feeder CL-100 after the heater. If there is no heater, install after the filter. Allowing concentrated chlorine to pass through the heater or filter may cause damage.

3. The chlorinator have 1 1/2" female threads. Socket adapters may also be used.

4. Use pipe thresd sealants formulated and approved for the use with plastic connections Do not over tighten.

5. Firstly, the preferred installation is above water level and located in line below filter or heater outlets. Secondly, an in-line positive seal corrosion resistant check valve should be installed to reduce backflow of chlorine gas when the system is shut off. Last but not at least, If the Chlorine Feeder CL-100 must be located below water level, provide a check valve to prevent water backflow when opening/servicing the unit.